|FHWA > Engineering > Pavements > Research > LTPP > The LTPP Newsletter|
Volume 4, Issue 3
PDF Version (140 kb)
Texas Uses Long-Term Pavement Performance (LTPP) Data to Calibrate the M-E PDG Permanent Deformation Models
The Mechanistic-Empirical Pavement Design Guide (M-E PDG) represents a major change from the way pavement design has been done in the past. The designer first considers site and construction conditions in proposing a trial design for a new pavement or rehabilitation. The trial design is then evaluated for adequacy through the prediction of key distresses and roughness. If the design does not meet desired performance criteria, it is revised and the evaluation process is repeated as necessary. Thus, the designer has the flexibility to consider different design features and materials for the prevailing site conditions. As such, the M-E PDG is not a design tool but a very powerful and comprehensive pavement analysis tool.
The M-E PDG as provided by the Transportation Research Board’s National Cooperative Highway Research Program was calibrated nationally by taking into consideration the various climatic regions across the country. If calibration coefficients are used for pavement design in Texas, the design could be either an over-estimate or an under-estimate for another region or State because materials, environmental conditions, and construction practices in Texas differ from the national average. The same will apply to any other State.
Dr. Jorge A. Prozzi, Associate Professor of Civil Engineering at the University of Texas at Austin, and his research team conducted a study with the objective of calibrating the asphalt concrete (AC) rutting model predicted with the current M-E PDG to actual infield performance of pavement sections in Texas. The study focused on finding two bias correction factors (Levels 2 and 3) for the AC rutting transfer function, per region, that are consistent with intermediate/ regional level designs.
The data used in the calibration process were taken from the Inventory, Monitoring, and Traffic modules of the LTPP database. The pavement sections included as part of this study are from the Specific Pavement Study (SPS) experiments; SPS-1 and -3. The SPS-1 experiment examines the effects of climatic region, subgrade soil, and traffic rate on pavement sections incorporating different levels of structural factors.
Figure 1. Five Study Sites in Texas
These factors include drainage, AC surface thickness, base type, and base thickness. The SPS-3 experiment compares the effectiveness and mechanisms by which the selected maintenance treatments preserve and extend pavement service life, safety, and ride quality. The study factors for flexible pavements include climatic zone, subgrade type, traffic loading, initial condition, and structural adequacy.
The regional calibration factors were obtained by minimizing the sum of squared errors between observed and predicted surface rutting. In this case, a simultaneous joint optimization routine was used because it is theoretically sound. Finally, an average of the regional calibration coefficients for AC and subgrade rutting was computed to obtain the set of state-default calibration coefficients for Texas.
This work was performed under research project 0-5513, The Development of the Texas Flexible Pavement Database, sponsored by the Texas Department of Transportation. The final research report, that provides the results obtained from this extensive effort to calibrate the permanent deformation
LTPP Database Server Relocation
This spring, the LTPP program successfully completed the transfer of the LTPP Information Management System (IMS) server from the Technical Support Services Contractor (TSSC) in Oak Ridge, Tennessee, to the new LTPP Information Center at the Turner-Fairbank Highway Research Center in McLean, Virginia. Everything went smoothly, and the TSSC staff did a great job of setting up the system and training LTPP Team members on basic Oracle database operations.
Figure 2. Training Session for LTPP Server Procedures
The new LTPP Information Center contains three main components:
Figure 3. The LTPP Information Center
LTPP Forensic Studies Update
The LTPP forensic studies announced in the last LTPP Newsletter Spring 2008 are complete for test sections at two sites: the New York SPS-8 and the Ohio SPS-1. Studies are planned at two other sites: the Arizona SPS-5 and the Texas SPS-5. The test sections are hot-mix asphalt surfaced pavements that exhibit cracking and some rutting. Information on the results of these studies will be coming soon. For more information about the ongoing LTPP forensic project, contact Jack Springer by phone at (202) 493-3144 or email firstname.lastname@example.org.
1 Texas Dept. of Transportation (2008), Research Project 0-5513, The Development of the Texas Flexible Pavement Database, Ambarish Banerjee, José P. Aguiar-Moya, and Jorge A. Prozzi, PhD, Dept. of Civil, Architectural, and Environmental Engineering, University of Texas at Austin. (Soon to be published at CTR Reports Online at www.utexas.edu/research/ctr/pdf_reports/index.html)
PDF files can be viewed with the Acrobat® Reader®