U.S. Department of Transportation
Federal Highway Administration
1200 New Jersey Avenue, SE
Washington, DC 20590
202-366-4000


Skip to content
Facebook iconYouTube iconTwitter iconFlickr iconLinkedInInstagram

Federal Highway Administration Research and Technology
Coordinating, Developing, and Delivering Highway Transportation Innovations

Report
This report is an archived publication and may contain dated technical, contact, and link information
Publication Number: FHWA-RD-07-052
Date: September 2007

Long Term Pavement Performance Project Laboratory Materials Testing and Handling Guide

Protocol H04L
Viscosity of Asphalts (AE06S)

This LTPP protocol covers the determination of absolute viscosity. It is intended to be used on asphalt cements extracted from cores taken as a part of the SPS-3 studies.

The absolute viscosity of asphalt cements shall be determined by vacuum capillary viscometers at 60°C (140°F). The test shall be performed in accordance with AASHTO T202-89I, Standard Method of Test for Viscosity of Asphalts by Vacuum Capillary Viscometer, except as designated below. Asphalt Institute viscometers shall be used.

The results will be recorded on LTPP Test Sheet H03. Comments shall include LTPP standard comment code(s) as shown in Section 4.3 of this Guide, and any other note as needed. An additional code for special comments associated with the testing is given below.

Code Comment
18 Insufficient material to perform test. Test was not performed.
20 Insufficient asphalt cement to perform Protocol H03L (penetration and H04L (viscosity) on separate samples. The penetration sample was reused for the viscosity test.

LTPP LABORATORY MATERIAL HANDLING AND TESTING
LABORATORY MATERIAL TEST DATA
VISCOSITY OF BITUMINOUS MATERIALS
LAB DATA SHEET H03

ASPHALT CONCRETE
LTPP TEST DESIGNATION AE06S/LTPP PROTOCOL H04L

LABORATORY PERFORMING TEST: _____________________________________________________________

LABORATORY IDENTIFICATION CODE: ___ ___ ___ ___

REGION: _________________________ STATE: STATE CODE: __ __

EXPERIMENT NO: _____ SHRP ID: __ __ __ __

SAMPLED BY: _________________________________________ FIELD SET NO: ___

DATE SAMPLED: __ __ - __ __ - __ __ __ __ SAMPLING AREA NO: SA- ____

1. LAYER NUMBER ___

2. LABORATORY TEST NUMBER __

3. LOCATION NUMBER __ __ __

4. LTPP SAMPLE NUMBER __ __ __ __

5. TEST RESULTS

      (a) VACUUM CAPILLARY (ABSOLUTE) VISCOSITY, poise __ __ __ __

      (b) TEST TEMPERATURE, °C __ __ __

      (c) VACUUM, mm Hg __ __ __

6. COMMENTS

      (a) CODE ___ ___ ___ ___ ___ ___ ___ ___ ___ ___ ___ ___

      (b) NOTE _______________________________________________________

7. TEST DATE __ __ - __ __ - __ __ __ __

GENERAL REMARKS:___________________________________________________________________________
SUBMITTED BY, DATECHECKED AND APPROVED, DATE
____________________________________________________________
LABORATORY CHIEF
Affiliation______________________
Affiliation______________________

 

<< PreviousContentsNext >>
Federal Highway Administration | 1200 New Jersey Avenue, SE | Washington, DC 20590 | 202-366-4000
Turner-Fairbank Highway Research Center | 6300 Georgetown Pike | McLean, VA | 22101