U.S. Department of Transportation
Federal Highway Administration
1200 New Jersey Avenue, SE
Washington, DC 20590
202-366-4000


Skip to content
Facebook iconYouTube iconTwitter iconFlickr iconLinkedInInstagram

Federal Highway Administration Research and Technology
Coordinating, Developing, and Delivering Highway Transportation Innovations

Report
This report is an archived publication and may contain dated technical, contact, and link information
Publication Number: FHWA-RD-07-052
Date: September 2007

Long Term Pavement Performance Project Laboratory Materials Testing and Handling Guide

Protocol H19L
Determination of Asphalt Content from Slurry Seal Sample (SC12)

This LTPP protocol covers the determination of asphalt cement content from slurry seal samples taken in the field as a part of the SPS-3 studies. The extraction shall be performed in accordance with AASHTO T164-89I, Standard Method of Test for Quantitative Extraction of Bitumen from Bituminous Paving mixtures, except as designated below. Reagent-grade trichloroethylene shall be used as the reagent required in paragraph 4. Method A shall be followed. The sample shall be taken from the slurry seal sample taken in the field. A 3- to 3.5-lb (1.4- to 1.6-kg) representative sample shall be taken from the sample submitted for testing.

The moisture in the sample shall be tested in accordance with AASHTO T110-88I, Standard Method of Test for Moisture or Volatile Distillates in Bituminous Mixtures, except as designated below. Xylene will be used as the solvent required by paragraph 2.4. Tests listed in Paragraph 6 will be omitted.

The results will be recorded on LTPP Test Sheet H17.

LTPP LABORATORY MATERIAL HANDLING AND TESTING
LABORATORY MATERIAL TEST DATA
DETERMINATION OF ASPHALT CONTENT FROM SLURRY SEAL SAMPLE

LAB DATA SHEET H17
SLURRY SEAL PROPERTIES
LTPP TEST DESIGNATION SC12/LTPP PROTOCOL H19L

LABORATORY PERFORMING TEST: _____________________________________________________________

LABORATORY IDENTIFICATION CODE: ___ ___ ___ ___

REGION: _________________________ STATE: STATE CODE: __ __

EXPERIMENT NO: _____ SHRP ID: __ __ __ __

SAMPLED BY: _________________________________________ FIELD SET NO: ___

DATE SAMPLED: __ __ - __ __ - __ __ __ __ SAMPLING AREA NO: SA- ____

1. LAYER NUMBER ___

2. LABORATORY TEST NUMBER __

3. LOCATION NUMBER __ __ __

4. LTPP SAMPLE NUMBER __ __ __ __

5. TEST RESULTS

      (a) MOISTURE IN MIXTURE, % __ __.__

      (b) ASPHALT CONTENT, % __ __.__

6. COMMENTS

      (a) CODE ___ ___ ___ ___ ___ ___ ___ ___ ___ ___ ___ ___

      (b) NOTE _______________________________________________________

7. TEST DATE __ __ - __ __ - __ __ __ __

GENERAL REMARKS:___________________________________________________________________________
SUBMITTED BY, DATECHECKED AND APPROVED, DATE
____________________________________________________________
LABORATORY CHIEF
Affiliation______________________
Affiliation______________________
<< PreviousContentsNext >>
Federal Highway Administration | 1200 New Jersey Avenue, SE | Washington, DC 20590 | 202-366-4000
Turner-Fairbank Highway Research Center | 6300 Georgetown Pike | McLean, VA | 22101